HomeAdmin
 %FFVER%

Admin
Password
Address
System
OLSR
Wireless
Ethernet
Software
Restart
Firmware
Publish
Back

Admin: Restart

Normal restart
Restart in failsafe mode
Restart in read-only mode (for firmware update)
Restart with initializing ("Format hard disk", Duration: 2 minutes)
Restart with the boot loader defaults. This option is tested only for these devices: Linksys WRT54G + WRT54GS! For the Siemens SE505 manually save the et0macaddr and il0macaddr NVRAM variables to restore them afterwards.
 
   

Please note: The boot_wait config setting has an actual value of "$(nvram get boot_wait)". To open up the possibility to upload a new firmware via TFTP, the restart will change this setting to "on".

Attention: The extended restart options are active with the Freifunk firmware only.

Tip: In failsafe mode, the IP address of the device is always 192.168.1.1. While you wait for the device to come up again, the network card can be configured to the appropriate IP address, for example to 192.168.1.2.

Changed: 4.9.2006
 Top of page